> Rated Power: 15W
> Working Voltage: 85-264VAC, 47-63Hz.
> Tube Dimension: L418*W38*H17mm
> LED Quantity: 220pcs SMD LED
> Efficiency: 90% Min.
> Luminous Flux: 1250 Lm+/-10%
> Colour Rendering Index: 80 Ra.
> Colour Temperature: 4000K ~ 6500K
> Product Life: >50K Hrs.
> Power Factory: 0.85~0.99
> Working Temperature: -40 ~ +55 Degrees
> Working Humidity: 95% RH
> Shell Type: Clear Shell; Frosted Shell;
> Certification: CE & RoHs
40pcs/Carton; Carton dimension L450*W200*H100mm; G.W.: 11KG
12W 2G11 LED light tube can replace Philips 2G11 36W Lighting, utilized high brightness SMD LED chipset as light source made from Taiwan, the chipset has stable reliability, high luminance and high color rendering index, has been widely used as home illumination and commercial illumination in Office, Factory, Hotel, Shop, Mall, Advertising and so on.
Adopt high efficiency light guide lens, the case and PCB were made with aluminum material which helps to reduced self temperature of LED chipset, so make the led with longer lifespan, the product has a life time of 50K hours, light loss will be less than 5% within 1000 working hours.
The constant current LED driver was built in the light tube, no flicker, even illumination, the led driver has over voltage protection, over current protection, short circuit protection and surge protection.
Do not need any Ballast, Starter, simply for installation, low cost for maintenance, no delay at light on,
No UV & IR, No radiation, No electromagnetic interference, Energy saving and environmental protection, No hazard material as Hg & Leads.
Energy saving about 75% compared with traditional lights, it is really a Green product to our life.
After Sales Service：
1. If the product was damaged due to product quality issues, then please contact our sales immediately, we will arrange to ship the new product to customer, we will be charge for all costs, we can also return customer all funds.
2. Our guaranteed is 2 years, the product design life is 10 years.
The products must be installed by authorization person.
1. Switch off the main power.
2. Take down the old light tube, Ballast and starter, not need replace the bracket
3. Connect the Line and Neutral wire separately to two end of lamp holder.
4. Fix up the cover board to bracket.
5. Connect the LED Light tube to the lamp holder.
6. Finished the installation.
7. Turn on the main power, the light tube will be light up immediately.